SEARCH BY CATEGORIES
SEARCH BY INSPIRATIONS
  • SEARCH BY MOTORCYCLE BRAND
    PLUS DE MOTO
  • Add description, images, menus and links to your mega menu

  • A column with no settings can be used as a spacer

  • Link to your collections, sales and even external links

  • Add up to five columns

  • Add description, images, menus and links to your mega menu

  • A column with no settings can be used as a spacer

  • Link to your collections, sales and even external links

  • Add up to five columns

  • Installation & Safety Notice – Premium Leather Seat (Plug-and-Play) Triumph Modern Classics 2016

    Installation & Safety Notice — Handmade Full-Grain Leather Seat

     

    This replacement seat upgrades comfort and style while retaining the OEM latch, height and rubber bump-stops. Passenger-carrying rules and seat-anchorage checks vary worldwide — review the table below before road use.

     

    Region Key Rules / Tests Your Checklist
    USA FMVSS 122 (brake hose clearance) & FMVSS 213 (no passenger restraint) Seat pan must not pinch ABS hose or wiring.
    Confirm rear lamp/plate visibility unchanged.
    Keep lot/serial for warranty & NHTSA defect reporting (5 yrs).
    EU / UK Reg. (EU) 168/2013 & MOT/ITV inspection Seat height ±3 mm vs. type-approval → category unchanged.
    MOT fails if seat loose — verify latch clicks positively.
    Optional logo embroidery must not exceed 4 mm relief (sharp-edge rule).
    Australia / NZ ADR 4/06 seat anchorages & ADR 57/00 hand-hold (if pillion fitted) Seat attaches to OEM fixtures — no mod code needed.
    If carrying a passenger, retain grab-strap or add accessory rail.
    Seat latch M8 bolt torque 25 N·m (18 lbf·ft).

    Universal Fitting Instructions

    • Remove OEM seat; clean latch pin and apply light grease.
    • Slide new seat’s front tongue under tank lip, then press rear downward until a clear click is heard.
    • Pull upward lightly to verify secure engagement.
    • If fit is tight, adjust underside rubber pads ±1 mm for even contact.
    • After first ride, re-check latch and bump-stop compression.

    Care & Maintenance

    • Treat full-grain leather every 3 months with pH-neutral balm.
    • Avoid high-pressure washers on seams; wipe spills immediately.
    • Store bike with supplied breathable cover to minimize UV fade.

     

    ⚠️ Riding with an unlatched seat or exceeding the manufacturer’s GVWR can cause sudden movement, loss of control and serious injury. Always verify latch engagement before each ride.

     

    ⚠️ California Proposition 65: This product can expose you to chemicals including chromium (leather tanning) and polyurethane foam. For details visit P65Warnings.ca.gov.