SEARCH BY INSPIRATIONS
- Air filters
- Brake & Clutch levers
- Electric box
- Exhaust
- Fenders
- Footpegs
- Front protections
- Front suspension
- Front suspension protections
- Fuel tanks
- Handle grips
- Handlebar
- Handlebar switch controls
- Headlights
- License plate holder
- Mirrors
- Mudguards
- Rear frame
- Suspensions
- Seats
- Silencers
- Speedometers
- Taillights
- Thermal strips
- Turn signals
- Air filters
- Belows front suspensions
- Brake & clutch levers
- Electric box
- Engine protection
- Exhaust
- Fenders
- Foot pegs
- Front suspensions
- Fuel tanks
- Handle grips
- Handlebar switch controls
- Handlebars
- Headlights
- License plate holder
- Mirrors
- Mudguards
- Rear frame
- Rear light
- Rear suspensions
- Seats
- Silencers
- Speedometers
- Thermal strips
- Turn signals
- Air filters
- Belows front suspensions
- Brake & Clutch levers
- Electric box
- Exhausts
- Fenders
- Foot pegs
- Front suspensions
- Fuel tanks
- Handle grips
- Handlebar switch controls
- Handlebars
- Headlights
- License plate holders
- Mirrors
- Mudguards
- Rear light
- Rear suspensions
- Seats
- Silencers
- Speedometers
- Thermal strips
- Turn signals
- Air filters
- Belows front suspension
- Brake & Clutch levers
- Electric box
- Exhaust
- Fenders
- Foot pegs
- Front protection
- Front suspensions
- Fuel tanks
- Handle grips
- Handlebar switch controls
- Handlebars
- Headlights
- License plate holders
- Mirrors
- Mudguards
- Rear frame
- Rear light
- Rear suspensions
- Seats
- Silencers
- Speedometers
- Thermal strips
- Turn signals
- Air filters
- Belows front suspensions
- Brake & Clutch levers
- Electric box
- Engine protection
- Exhausts
- Fenders
- Foot pegs
- Front suspensions
- Fuel tanks
- Handle grips
- Handlebar switch controls
- Handlebars
- Headlights
- License plate holders
- Mirrors
- Mudguards
- Rear frame
- Rear light
- Rear suspensions
- Seats
- Silencers
- Speedometers
- Thermal strips
- Turn signals
SEARCH BY MOTORCYCLE BRAND
Installation & Safety Notice – Carbon Engine Cover for BMW R 18
Installation & Safety Notice — Carbon-Fiber Engine Cover
BMW R 18 (all model-years)
This genuine carbon-fiber cover is a styling accessory that clips over the original left-side engine housing (front main cover). It does not replace a structural or heat-shield component. Regulations and heat/ clearance rules differ worldwide—consult the table below before road use.
| Region | Key Rules | Your Checklist |
|---|---|---|
| USA | EPA tamper & FMVSS 301 fuel-system integrity | Cover must not touch fuel lines or block crank-case breather. Carbon piece is cosmetic—do not remove OEM aluminium housing. If engine leaks develop, remove cover and inspect immediately. |
| EU / UK | Reg. (EU) 168/2013 (Euro 5) — no emissions change allowed | Ensure cover leaves original PCV vent clear. Cannot be used with aftermarket open crank-case filters unless certified. |
| Australia / NZ | ADR 42/04 (general safety) + ADR 79/04 (Euro 5) | Cover must not cause oil leaks or overheating; maintain >5 mm gap to exhaust header. Use supplied heat-resistant foam pads to avoid abrasion. |
Universal Fitting Instructions
- Clean OEM engine cover with isopropyl alcohol; let dry.
- Affix the supplied 3 M™ VHBTM pads to the inside of the carbon part, peel liners, align with BMW logo recess, and press firmly for 30 s.
- Temperature for bonding: 15 – 30 °C (59 – 86 °F). Avoid riding for 24 h to allow adhesive cure.
- Maintain a minimum 5 mm clearance from exhaust header; trim pad thickness if necessary.
- Inspect after the first heat-cycle; re-torque any bolt-on dress caps to 3 N·m (27 lbf·in).
Maintenance & Heat Limits
- Carbon epoxy Tg = 120 °C (248 °F). Do not use caustic cleaners or point heat-guns at the surface.
- If the bike is left idling for extended periods in hot weather, check that surface temperature stays < 100 °C.
- Clean only with mild soap & water; avoid fuel spills—wipe immediately.
⚠️ Installing over moving or hot components without the specified clearance can cause adhesive failure, rattling, abrasion of oil lines, or fire hazard. Install and use at your own risk.
⚠️ California Proposition 65: This product can expose you to chemicals including styrene and carbon-fiber dust. For more information visit P65Warnings.ca.gov.